CMXY 4V/41V - Störung | Sound Art & Professional Audio Störung | Sound Art & Professional Audio

CMXY 4V/41V

Schoeps traditionally has great expertise in the field of stereophony and uses this for its products. Various stereo microphones and special accessories for M/S, X/Y, Blumlein, ORTF and A/B stereophonic recording allow the optimal arrangement to be selected for every application.
The Colette series stereo sets are among our best-selling products.
These microphones consist of two directly connected microphone capsules, making them “real” stereo microphones. The microphones realize well-known stereophonic recording setups such as XY or ORTF.






Properties
– Stereo microphone for XY recording
– Contains two side-addressed cardioids or supercardioids
– Compact, elegant and lightweight
– The angle between the microphones can be adjusted between 0° and 180°
– For music recording or conference situations

Description
The CMXY is a compact, elegant X/Y stereo microphone.
It is used for music recordings and in conference situations (e.g. on podiums or altars), during discussion sessions, and as a stereophonic spot microphone.
The CMXY 4V is equipped with two 4V cardioids. It is a classic cardioid X/Y microphone. If the angle between capsules is set to 90°, a stereophonic recording angle of 180° will result (see www.ima.schoeps.de).
The CMXY 41V is equipped with two 41V supercardioids. It is an X/Y microphone with improved spatial reproduction, since the channel correlation in the diffuse field is lower than with a cardioid X/Y microphone. If the angle between capsules is set to 90°, a stereophonic recording angle of 130° will result (see www.ima.schoeps.de). The CMXY is also available with integrated table stand.
The CMXY is only available in version “U” – with XLR-5M output plug; The adapter cable AK SU/2U (XLR-5F to 2 × XLR-3M) is included. Dedicated wind basket is available from Cinela: Zephyx-CMXY

Practice
Unlike conventional microphones which have one fixed and one rotatable capsule, the angle between the capsules of the CMXY 4V (and hence the recording angle, which is the range within which the sound sources should be placed, as “seen“ by the microphone) can be adjusted without affecting the main stereo axis. The capsules always rotate equally and in opposite directions by means of an ingenious gear arrangement in the base of the microphone. This greatly simplifies setting up the microphone.
The CMXY 4V has balanced outputs at an impedance of only 90 Ohms. This allows cable lengths of up to several hundred meters to be used without loss of sound quality, while the risk of electromagnetic interference is greatly reduced.
When any microphone is placed near (but not directly onto) a flat surface, comb-filter effects will occur. These can be reduced if the surface (e.g. the table top) is covered with perforated material.

Technical Specifications

CMXY 4V

Pickup pattern Cardioid (2x CCM 4V)
Frequency range 40 Hz – 19 kHz
Sensitivity -36 dB (V/Pa), 15 mV/Pa
Equivalent noise level (A-weighted) 13 dB
Equivalent noise level (CCIR) 23 dB
Signal-to-noise ratio (A-weighted) 81 dB
Maximum sound pressure level (THD < 0.5 %) 131 dB-SPL
Maximum output voltage ca. 1 V (0 dBV) with 1 kΩ load
Low cut filter 20 Hz, 12 dB/oct.
Minimum recommended load impedance 1 kΩ
Output impedance 90 Ω
Maximum cable length > 300 m
SCHOEPS RFI Shield
Powering standard/Valid range P48 / >41 V & P12 / >11 V
Current consumption 4 mA (P48) & 8 mA (P12)
OutputXLR-5M, analog, 2 channels
Common mode rejection ratio (at 1 kHz) > 60 dB
Distance between the microphones 2 cm
Recording angle 90°-180°
Length I-version: 110 mm, U-version: 119 mm
Width without gear wheels: 41 mm
Depth without gear wheels: 20 mm
Weight 189 g
Surface finish matte gray (g) or custom color
Stereophonic recording technique XY
Stereophonic recording technique XY

CMXY 41V – IDENTICAL TO CMXY 4V, EXCEPT OF:

Pickup pattern Supercardioid
Frequency range 40 Hz – 17 kHz
Equivalent noise level (A-weighted) 14 dB
Signal-to-noise ratio (A-weighted) 80 dB