CMC 6xt

835,00 21% TAX included

Microphone amplifiers Impedance converter. In addition to the standard, phantom-powered CMC 6 amplifier type, SCHOEPS also offers the CMC 6xt type for recordings up to 40 kHz and the CMR type for use with pocket transmitters.

Categories: ,


The CMC 6xt is the HiRes version of the CMC 6.
Using this amplifier, the frequency range of all axially-addressed capsules (MK 2 H/S, 21, 22, 4, 41, 5) can be extended up to 40 kHz
Especially useful when recording with a high sample rate, particularly with the intent to slow down the recording and reduce its pitch by one or more octaves at a later point (e.g. for sound design)

The CMC 6xt extends the frequency response of the MK capsules up to 40 kHz.
Attention was paid to a low self-noise above 20 kHz. This maintains a high level of dynamics when recording at high sampling rates. Thus, the often very small signal above 20kHz is not covered and the noise is still low even after the down pitching.

Technical specifications

Technical Specifications

Frequency range 20 Hz – 60 kHz
Sensitivity see corresponding capsule (same as CMC 6)
Maximum output voltage 1 V (0 dBV) with 1 kΩ load
Low cut filter 20 Hz, 12 dB/oct.
Minimum recommended load impedance 1 kΩ
Output impedance 42 Ω
Maximum cable length > 400 m
Powering standard / Valid range P48 / >20 V & P12 / >10 V
Current consumption 4 mA (P48) & 8 mA (P12)
Common mode rejection ratio (at 1 kHz) > 60 dB
Output XLR-3M, analog, 1 channel
Length 116 mm
Diameter 20 mm
Weight 60 g
Surface finish matte gray (g) or custom color